Fisher & Paykel DD60 manual Cleaning the spray arm and filter plate

26

Care and cleaning

Cleaning the spray arm and filter plate

Ensure the DishDrawer® is cool before you start cleaning and follow the instructions for removing the drain filter and spray arm.

1	Unplug the DishDrawer® or turn it off at the
	power supply.		2
2	Unclip the glass supports from the rack wires and			3
	fold all the adjustable racks away, so that they are
	upright and close to the top.
3	Remove the base rack carefully. Lift from the
	back end first to prevent knocking the		2
	detergent and rinse aid dispenser.
4	Lift the spray arm and shake any foreign material		3	4
	out.
				4
	Rinse the spray arm clean under running water		5
	and wipe with a damp cloth.			6
5	In the centre of the filter plate there are two rings.
	Hold the centre ring still and turn the outer ring
	anti-clockwise, about a 1/8 turn. This will release
	the filter plate.		a
6	Lift the filter plate out.
	When cleaning the underside of the filter plate,
	take care handling the sharp outer edge to avoid
	the risk of cuts.	b
	Remove any foreign material, wash in hot soapy			e
	water and rinse thoroughly in clean water. The
	heater plate can be wiped with a damp cloth.	c
7	Replace the filter plate so it lies flat in the base of
	the drawer ensuring the filter plate is fully locked
	into position with the centre ring.		d
	Important!
		Correct locking position of filter
	To lock the filter plate into position, ensure the lines align
		plate with motor assembly
	with each other (c) and all three pin pairs firmly interlock (e).
		(under spray arm)
	Refer to the diagram for the correct position.
		a	Outer ring
	The filter plate must not be able to move about freely.
		b	Impeller
8	Replace the spray arm back onto the impeller.
		c	Correct alignment marks
9	Replace the base rack, lowering its front edge into
		d	Centre ring
	position first.
		e	Interlocking pins
10	Plug the DishDrawer® back in or turn it on at the

power supply.

Note: Where there is broken crockery or glass in the drawer, it must be carefully removed to prevent damage to the DishDrawer®.