Manuals / Fisher & Paykel / Kitchen Appliance / Dishwasher

Fisher & Paykel DD605 installation instructions Nz Au Gb Ie, Part No. 529322 A

Models: DD605

1 28

Page 28

The product specifications in this booklet apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement, these specifications may change at any time. You should therefore check with your Dealer to ensure this booklet correctly describes the product currently available.

www.fisherpaykel.com

NZ AU GB IE

DishDrawer installation instructions Published: 06/2007

Part No. 529322 A

Page 28

Image 28

Fisher & Paykel DD605 installation instructions Nz Au Gb Ie, Part No. 529322 A

Contents

Installation instructions DishDrawerNZ AU GB IE DD605 and DS605 modelsSafety and warnings Important safety precautionsElectrical hazard Cut HazardContents SAVE THESE INSTRUCTIONS2Product dimensions DOUBLE MODELSCabinetry dimensions Cabinetry dimensions mmMinimum clearances mm DOUBLE MODELS4Cavity preparation Parts suppliedDOUBLE MODELS to prevent moistureRoute the hoses and move into the cavity 3 3optional DOUBLE MODELS6Removing the tub and levelling the product 30 mmSecuring the product and refitting the tub DOUBLE MODELSoptional B B A A8Plumbing and drainage - OPTION Power cordDishDrawer and Standpipe Ø38 mm DOUBLE MODELSPlumbing and drainage - OPTION 1 connection DishDrawer and Standpipe Ø38 mmDOUBLE MODELS 180o10Plumbing and drainage - OPTION DishDrawer using sink trap with drain hose joinerDOUBLE MODELS HIGHLOOPDishDrawer using sink trap with drain hose joiner Plumbing and drainage - OPTION 2 connectionDOUBLE MODELS DOUBLE MODELS Fitting the toekickD o not overtighten screw Page 14Product dimensions SINGLE MODELSCabinetry dimensions Cabinetry dimensions mmSINGLE MODELS B D A C16Cavity preparation CavitySINGLE MODELS min. 4.5 ARoute the hoses and move into the cavity SINGLE MODELSTie together to avoid kinking Ensure hoses and cord18Removing the tub and securing the product SINGLE MODELSRefitting the tub Ensure the tub clips on 5 both sides are resetSINGLE MODELS Ensure the tub is20Plumbing and drainage - OPTION Power cordDishDrawer and Standpipe Ø38 mm SINGLE MODELSPlumbing and drainage - OPTION 1 connection DishDrawer and Standpipe Ø38 mmSINGLE MODELS 180o22Plumbing and drainage - OPTION DishDrawer using sink trap with drain hose joinerSINGLE MODELS HIGHLOOPPlumbing and drainage - OPTION 2 connection DishDrawer using sink trap with drain hose joinerSINGLE MODELS If space is limitedTroubleshooting Final checklistRepeat for each Drawer Page NZ AU GB IE Part No. 529322 A