(2,1)
4PARTS SUPPLIED
Drain hose | Drain hose | Wire clip (2) | Clamp (1) | Top | Phillips | Rubber | Moisture protection | Hexagonal | Prefinished toekick (1) |
support (1) | joiner (1) |
|
| mounting | 16 mm | washer for | tape (1) | socket (2) | white or black |
|
|
|
| brackets (2) | screws (9) | inlet hose (1) | (to prevent moisture | (long & short) |
|
|
|
|
| OPTIONAL |
|
| damage) |
|
|
If the Drain hoses supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hoses by 3.6 m. The kit is available from the nearest Fisher & Paykel Authorised Service Centre or our local website listed at the end of this document.
5CAVITY PREPARATION
These marks indicate mounting bracket screw locations
*Preferred position. If adequate clearance, services hole can be higher to clear toekick space.
If hole is higher, ensure drain hoses are routed straight into the waste connection.
Water Connection
Recommended COLD (Maximum 60°C). ¾ “ BSP (GB20) to suit flat washer.
|
|
|
| Moisture protection | |
|
|
|
| ||
|
|
|
| ||
10 mm | |||||
tape must be applied. | |||||
|
|
| can | be | located | |
| Services | . | ||||
Note: |
| |||||
|
| |||||
side | of DishDrawer® | |||||
either | ||||||
|
|
|
| |||
|
|
|
|
| ||
Water Pressure | Max | Min |
Water softener models | 1 MPa (145 psi) | 0.1 MPa (14.5 psi) |
Other models | 1 MPa (145 psi) | 0.03 MPa (4.3 psi) |
Drains will need to be separated to satisfy kosher requirements.
We suggest you confirm acceptability with your local rabbi in respect to kosher installations.
max. 450 mm | Water supply |
min. ø60 mm
min. 200 mm
* 
* 
