Rinse aid
19
We highly recommend the regular use of liquid rinse aid to give the best drying results. Rinse aid gives a
Filling the rinse aid dispenser
1 Open the dispenser by turning the cap in an anticlockwise direction.
2 Pour the rinse aid into the dispenser, making sure not to overfill.
Take care not to spill rinse aid into the dishwasher. Any spills must be wiped up to prevent excess foaming. Failure to wipe
up rinse aid spills may result in a service call, which will not | Fig. 7 Opening the rinse aid dispenser |
| |
be covered by warranty. |
|
3 Fit the cap back in the original position. |
|
How much rinse aid to use
The dose regulator may need to be adjusted to suit your water conditions. Regulate the amount of rinse aid by turning the dose regulator, using a screwdriver. The dose regulator is located underneath the rinse aid cap.
There are six dosage settings; the lowest setting is ‘1’ and |
|
the highest setting is ‘6’. The normal dosage is setting ‘1’. If |
|
there is excessive foaming at the end of the wash, reduce the | Fig. 8 Adjusting the dose regulator |
setting. If dishes are wet or streaky after drying, increase the |
|
setting. |
|
Rinse Aid indicator light
When the rinse aid level becomes low, the Rinse Aid indicator |
|
will light up to remind you to refill the rinse aid. The Rinse Aid |
|
indicator light can be found on the detergent dispenser cover |
|
for all models, and on the exterior control panel |
|
for models DW60CDW2 and DW60CDX2. | Fig. 9 Rinse Aid indicator light |
