Installation instructions
Plumbing
5
Drainage
The recommended method of installation is shown in diagrams 1,2 and 3. The diagrams are designed to eliminate problems that occur with combined sink – dishwasher waste systems.
The standpipe must have a minimum diameter of 38 mm and stand 750mm above the floor. A drain hose support is provided to hold the drain hose in place in the standpipe (See diagrams 1 and 2). It is not recommended that the drain hose or drain pipe be connected directly to a waste disposal unit (see diagram 2).
When connecting the drain hose to a sink trap with a drain hose spigot, it is important that the drain hose is supported to the height of the bench (see diagram 3). Ensure the drain spigot has a minimum hole size of 15 mm and that it has been drilled out.
*
|
|
|
Switched power socket | Hose supplied | |
Diagram 1: Dishwasher
*
Switched power socket | Hose supplied |
Diagram 2: Dishwasher & waste disposal unit
Waste
Water
Waste 200 mm MIN
Waste disposal unit
Waste
Water
Waste 200 mm MIN
*Standpipe Ø38 mm
750 mm MIN above floor
*Standpipe Ø38 mm
750 mm MIN above floor
note:
Connection of drain hose direct to the waste disposal unit is NOT recommended.
Vent
Waste
Hose supplied | Water |
200 mm MIN
Switched power socket
Diagram 3: Dishwasher using sink trap with dishwasher drain hose spigot
