6
Installation instructions
12Attach double sided foam to the back of the water filter head as shown in Diagram 5. Write the date to be replaced on the filter (date installed + 6 months). Remove double sided foam backing and attach filter to the desired position as located in step 11 (refer to previous page).
13Run the 6 mm (¼”) tubing to back of the fridge ensuring there is enough tubing to pull out the refrigerator for service.
14Connect tubing into the water (solenoid) valve located on the right hand side of the unit (compressor) compartment as shown in Diagram 7. Beware of hot pipes.
15Pull gently on tubing to ensure it is locked in as shown in Diagram 8.
16The completed installation should look like Diagram 9 on page 7.
Diagram 5
Fig.8 Double sided foam attachment
Diagram 7 | Diagram 8 |
Fig.9 Waterline connection to refrigerator
Diagram 6
17Turn isolating tap on and check that all connections are dry and free of drips.
18Coil water line tubing behind the fridge. Push your refrigerator into place being careful not to kink or squash the water line running into the water (solenoid) valve.
19Turn on refrigerator.
20The first time you require water out of the dispenser, there will be a delay while the water reservoir fills up. As this is happening, the 
symbol will flash. Once the reservoir is full, this symbol will stop flashing.
21Run a further 3 litres (3 qt) through the system to ensure the reservoir is flushed out.
22You are now ready to enjoy chilled water and ice dispensing from your Active Smart™ refrigerator.
