MINIMUM SETTING OR TURNDOWN

PAGE 6 OF 6

This has been set at the factory for NG but can be checked after the correct pressure has been reached. To adjust for minimum setting, if needed. You will need a Ø 7/64 " x 1 3/4" (Ø2.5 x 45mm) screwdriver. (A suitable screwdriver is available as Fisher & Paykel spare part. FB200467).

1.Ignite the burner and set the knob to its minimum position.

2.Remove the knobs.

3.Rotate the turn down screw (down the hole in the spindle) while holding the shaft. Rotate slowly until a minimum regular flame is achieved. (The flame will diminish when the screw is turned clockwise and increase when turned counter clockwise).

4.When the setting is right check regulation by quickly rotating the knob from the maximum to the minimum delivery position. The flame must not go out and the autoreignition should not click. Replace the knob.

See the Product Installation Checklist attached to the product.

Minimum setting adjustment

(Note: this diagram is of GC901 but is similar for GC36).

A Service Summary is attached to the underside of the product.

For replacement parts or if further help is needed concerning this appliance call:

TOLL FREE 1 888 9 FNP USA (1 888 936 7872)

or write to:

Fisher & Paykel Appliances Inc.

27 Hubble, Irvine

CA 92618

or contact us through our web site,

www.usa.fisherpaykel.com

Page 6
Image 6
Fisher & Paykel GC36, GC901 dimensions Minimum Setting or Turndown