Before you begin, take note!
•Please keep this manual for future reference, as it contains important information.
•Adult assembly is required to install batteries.
•Tool needed for battery installation: Phillips screwdriver (not included).
•Requires four “AA” (LR6) alkaline batteries for operation (not included).
•Replace batteries when:
-Display on the screen becomes difficult to see.
-Toy functions erratically.
-Sounds become faint or there are no sounds at all.
•Use only the drawing stylus on the screen. Never use any other object, such as a regular pen or pencil, on the screen. Markings from regular pens or pencils cannot be removed and will damage the screen.
•Be sure to turn Pixter® power off before inserting a software cartridge (sold separately) into the software port. Turn Pixter power back on to play!
IMPORTANT! You must calibrate the stylus to the screen before
•Install four “AA” alkaline batteries. Turn Pixter power on. Wait until you see the Home Screen.
•Turn Pixter over and locate the calibration hole.
•Insert, push and hold the stylus in the calibration hole. Turn Pixter over so that you can see the screen. When you see two plus signs 
remove the stylus from the calibration hole.
•First touch the upper right corner 
with the tip of the stylus.
•Then, touch the lower left corner 
with the tip of the stylus.
3
