®
•Plug the charger into a standard 120 volt wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
•Before first-time use, charge the batteries for at least 18
hours. Never charge the batteries longer than 30 hours.
Note: The batteries must be upright while charging.
•Recharge the batteries for at least 14 hours after each
use of your vehicle.Do not charge the batteries longer
than 30 hours.
•Once the batteries are charged, disconnect the charger
connector from the battery connector.Unplug the
charger from the wall outlet.The batteries are now
ready to be installed in your vehicle.Please see the
Battery Installation section on page 15 for detailed
instructions on installing your batteries.If your batteries
are already installed in your vehicle, simply re-connect
the battery connector and motor harness connector and
close and lock the hood.
•If you are charging the batteries for the first time, insert a
30 amp fuse into each battery before charging.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
•If you are recharging your batteries, make sure the 30
amp fuses already installed in the batteries are in good
condition.Remove the fuses from the batteries and look
at them to make sure they are not blown.Replace a
blown fuse with a new Power Wheels®30 amp fuse.
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
®
®
30 Amp Fuse
14
®
®
•Stack one battery connector on top of the other and
snap them together.
Battery
Connectors
Battery Charging
2