Fisher-Price 78490 owner manual Push

Assembly

16	Short Seat	T-Loop (Pull through slot)
	Belt Strap
End		Fastener End
T-Loops
Slot

Seat

Slot

•Turn the seat upside down.

•Insert the fastener end of a short seat belt strap through the slot near the outer edge of the seat. Make sure the side of the seat belt with the fastener faces the outer edge of the seat.

•Pull the short seat belt strap completely through the slot until the last T-loop at the opposite end of the belt catches against the slot. You will pull one T-loop through the slot.

•Repeat this procedure to assemble the other short seat belt strap.

18
	Seat
Seat Back Tabs

Tabs

3	PUSH
	HERE

2

Slot

1

•With the seat at an angle, insert the tabs on the front edge of the seat into the slots in the foot-well wall 1 .

•Push down firmly on the edge of the seat above each tab to snap the tabs into the slots 2 .

•Rotate the back of the seat down 3 to snap the seat back tabs into the slots in the vehicle body. Push down firmly on the seat back.

17	Long Seat Belt Strap
T-Loop
Fastener End

•Insert each fastener end of the long seat belt strap through a slot in the center of the seat. Make sure the fasteners face the outer edge of the seat.

•Pull each side of the long seat belt strap evenly through the slots. Make sure to pull each T-loop through a slot.

•Turn the seat upright.

19 #8 x 1" Screw

•Insert a #8 x 1" screw into the rear of seat as shown.

•Tighten the screw with a Phillips screwdriver. Do not over-tighten.

14