Assembly
IMPORTANT! Before assembly, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact
| Front Legs |
| (Longer) |
Tapered End |
|
| Press |
| Button |
| Press |
| Button |
| Tapered End |
1 | Front Base |
Remote
Holder
Ribbon
3
•Place the front base on a flat surface.
•Position a front leg (longer) so that the tapered end is downward, as shown.
•While pressing the button on one of the front legs, insert it into the front base. Push down on the front leg until the button “snaps” into the hole in the front base.
•Repeat this procedure to assemble the other front leg to the front base.
Pull Up
Front Legs | Pull Up |
2 | Front Base |
|
•While standing on the front base, pull the front legs up. The front legs should remain secured to the front base. If you can remove the front legs, you have not assembled them correctly to the front base. Reread and repeat assembly step 1.
4
•Using scissors, remove the ribbon connecting the remote and the holder.
Holder 
Front
Leg Hole
| M4 Lock Nut |
| Rounded |
| Side |
| Shown Actual Size |
| Hexagonal Opening |
4 | M4 Lock Nut |
| (Rounded |
| Side Out) |
•Position the holder so that the open end faces forward, as shown.
•Slide the holder onto the front leg with a hole.
Hint: An M4 lock nut has been assembled to the holder at
the factory. During shipment of this product, it may have fallen out. Check to be sure there is a lock nut in the hexagonal opening on the holder. If it has fallen out, fit the lock nut back into the hexagonal opening. Make sure the rounded side of the lock nut faces out.
