Assembly
Frame
Decorated
Side
Frame
Back
Legs
Seat Height
Adjusters
Position 4
Base Hole
Screw
Retainers
8 | Base Hole |
|
#10 x 2.2 cm (7/8")
Black Screw - 2Screw Retainer - 2
SHOWN ACTUAL SIZE
•Position a frame so that the decorated side is outward.
•Insert the back legs of a frame into one of the bases.
•Fit a screw retainer over the hole in the base, as shown.
•Insert a #10 x 2.2 cm (7/8") black screw into the screw retainer and tighten.
•Repeat this procedure to fasten the other frame back leg to the other side of the base with a screw retainer and #10 x 2.2 cm (7/8") black screw.
Hint: The #10 x 2.2 cm (7/8") black screws may have been assembled to the screw retainers.
PressLever
9
•While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown.
Seat Assembly
Sockets | Sockets |
Seat Bottom
Tubes
10
•Fit the seat assembly between the two frames.
•Insert the seat bottom tubes into the sockets in each seat height adjuster.
Hints:
•Be sure the seat height adjusters are in the same position (position 4).
•You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets.
6