Assembly
IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replace- ment parts and instructions if needed. Never substitute parts.
Toy Bar
1 | Electronic Toy |
|
•Insert and “snap” the toy bar into the electronic toy, as shown.
f
Footrest
Seat Bottom
2
•Place the seat bottom face down on a flat surface.
•At an angle, fit the footrest on the seat bottom, as shown.
Plastic Rings
Seat Bottom Tubes
3
Plastic Rings
•Slide a seat bottom tube through each set of plastic rings on the seat bottom.
Plastic Rings
Seat Bottom Tubes
| Plastic Rings |
4 | #8 x 1.9 cm Screw - 4 |
•Align the holes in the plastic rings and the seat bottom tubes.
•Insert a #8 x 1.9 cm screw through each plastic ring and into the seat bottom tubes, as shown. Tighten the screws.
•Push the seat bottom tubes back and forth to be sure they are secured to the seat bottom. If the seat bottom tubes move, you have probably not fastened them properly. Remove the screws and check to be sure the screw holes in the seat bottom tubes and seat bottom plastic rings are aligned. Replace and tighten the screws.
4
