Assembly
Frame Decorated Side
Frame Back Legs
Back Base Hole
Screw Retainers
Back Base Hole
9 | Screw Retainer - 2 | #10 x 2.2 cm Black Screw - 2 |
|
|
•Position a frame so that the decorated side is outward.
•Insert the back leg of a frame into the back base.
•Fit a screw retainer over the hole in the back base, as shown.
•Insert a #10 x 2.2 cm black screw through the screw retainer and back base. Insert the back leg of a frame into the back base. Tighten the screw.
•Repeat this procedure to attach the other frame back leg to the other side of the back base.
Hint: The #10 x 2.2 cm black screws may have been assembled to the screw retainers.
Seat Height Adjusters
Position 4
Press Lever
10
•While pressing the levers on the seat height adjusters, lift them to position 4 on the frame front legs, as shown.
Seat Assembly
Sockets
11 | Seat Bottom Tubes |
|
•Fit the seat assembly between the two frames.
•Insert the seat bottom tubes into the sockets in each seat height adjuster.
Hints:
•Be sure the seat height adjusters are in the same position (position 4).
•You may need to push the frames apart slightly to fit the seat bottom tubes into the seat height adjuster sockets.
6