ASSEMBLY
46
Post
Grooves
Sleeve
Side Tube
Sleeve
Side Tube
•Slide a side tube, straight end first, through the sleeve on each side of the net.
• Fit the upper end of the side tubes into the groove in each post.
5
Side Tubes
•Lift the side tubes up and set the ends in the notch in each base assembly.
Hint: The top of the net will flop forward.
7
2
Base Covers | 1 |
•Note the numbers on the base covers.
•Fit the base cover labeled 1 onto the base assembly labeled 1 . Hint: Make sure the net is not under the base cover.
•Insert four #8 x 3/4” screws into the base cover and tighten.
•Repeat this procedure to attach the other base cover labeled 2 to the base assembly labeled 2 .
4
