Assembly
Handlebar
Frame Neck
Fork Post
Fork Cover
Rear of Trike
9
•Turn the frame upright.
•Insert the fork post up through the hole in the neck of the frame. Make sure the fork is positioned so that the fork covers face the rear wheels.
•Place the handlebar over the fork post and push it down onto the frame. Make sure the handlebar is positioned so that the screw hole faces the rear wheels and aligns with the screw hole in the fork post.
Hint: You may need to rotate the handlebar to align the holes.
•Insert the #8 x 3" (7,6 cm) screw through the hole in the handlebar and into the fork post. Tighten the screw with a Phillips screwdriver. Do not
Cap
10
• Insert and “snap” the cap into the hole in the frame.
Seat Retainer
Seat
Peg 
Holes
11
•Position the seat upside down.
•Fit the small pegs on the seat retainer into the holes in the seat.
1 |
|
2 |
|
6 | 3 |
|
|
| 4 |
|
7 | 7 | (Label 5 | on other side) |
|
| ||
|
|
|
12
•Make sure the areas where the labels will be applied are clean and dry. Wipe your vehicle with a clean, soft, dry cloth to remove any dust or oils.
•For best results, avoid applying a label more than once.
•Apply the labels as shown in the illustration above.
5
