Tough for Talking
•Turn the power/volume dial on the front of each walkie talkie to turn them on. The power L.E.D. lights to indicate that power is ON.
•Press and hold the talk button on the side of the walkie talkie and talk into the microphone.
•Release the talk button to listen to a response from the other walkie talkie!
•Walkie talkie range is dependant on environmental conditions. The range of the walkie talkies will be shorter when used indoors than it will when used outdoors.
•After fi ve minutes of inactivity, the walkie talkies will go into sleep mode. Press the talk button to turn it back on.
IMPORTANT! Always remember that you are using public frequencies when using these walkie talkies. You may fi nd that this product will occasionally pick up transmissions from other transmitting devices using the same frequency.
FCC Statement (United States Only)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifi cations not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
5
