ASSEMBLY CONTINUED
3. Assemble Legs
Connect curved leg sections to form a
FIGURE 6
Screw
Upper Leg Clamp
Leg
Hex Nut
Lower Leg Clamp
4 . Attach Spacer and Handle Grips to Legs
Locate holes on sides of horizontal portion of leg sections. Holes are located approximately 7" from end of leg.
Install a spacer on a #8 x 1/2" pan head phillips screw and fasten to outside surface of leg using a phillips screwdriver. Repeat for opposite side. See figure 7.
Place handle grips on horizontal ends of both leg sections.
FIGURE 7
Leg
Handle Grip
Spacer
Screw #8 x 1/2" Long
Do not remove friction pads located on left and right threaded stems.
5. Assemble Housing To Legs
Remove knobs and hubs from both sides of the housing by unscrewing knob and pulling hub off threaded stems located on either side of the housing. See figure 8.
Place housing on legs with funnel facing downward. Position with Flowtron
Insert threaded stem through hole in center of hub and fasten by threading knob onto stem. DO NOT OVER TIGHTEN. Repeat for opposite side. Position unit at desired angle and tighten left and right knobs
When making large changes in hous- ing angle or when placing housing in the storage position, Loosen knobs before rotating.
FIGURE 8
Flowtron
label
Threaded
Stem
Friction
Pad
Knob
Slot | Hub | Spacer |
page 5