ASSEMBLY
PREPARATION
Your Owner’s Manual has been developed to help you assemble the unit and to understand its safe operation. It is important that you read your manual completely to become familiar with the unit before you begin assembly.
1.Tools you will need
#2 phillips head screwdriver
1.Assemble Funnel
Place funnel halves on flat surface with narrow opening facing up. Align both halves and press locating pin nearest narrow opening of funnel half into locating hole on adjacent funnel half. See figure 3. Using two (2) #8 x 1/2” screws, fasten both halves together. See Figure 4.
N OT E : Flange on funnel half overlaps outer surface of adjacent funnel half as shown in figure 3.
FIGURE 3
Narrow End
of Funnel
Locating Pin
Hole
Locating Pin |
| FLANGE |
|
|
|
|
|
|
Rotate Funnel 180º and press locating pin nearest large opening of funnel half into locating hole on adja- cent funnel half. See figure 3. Using two (2) #8 x 1/2” screws, fasten both halves together. See Figure 4
FIGURE 4
Wide
Opening
#8 x 1/2” screw (two places)
Narrow Opening
2.Attach Funnel to Housing
Place narrow opening of funnel on upper end of hous- ing and position funnel so that flat areas of funnel are located at the right and left housing towers. Align boss on funnel with hole at top center of housing tower as shown in figure 5. Repeat for opposite side. With boss- es aligned, press funnel firmly down onto housing. Apply pressure all around edge of funnel until funnel is seated evenly around the housing. Fasten funnel to right side of housing by inserting a #10 x 3/4" long pan head phillips screw into large screw hole opening at top front edge of housing tower, and tighten using a phillips screwdriver. CAUTION: Do not over tighten screw. See figure 5. Repeat for left side.
NOTE: While inserting screw into screw hole opening, keep funnel tab in place by pressing down on inside surface of funnel opposite tab so that screw passes through hole in funnel tab.
FIGURE 5
Funnel
Push
Screw
Funnel #10 x 3/4" Long
Boss
Housing
Tower
Funnel Tab
page 4