LF Serial linefeed parameter
Press “SET” to access the linefeed parameter.
LF= On Current linefeed setting
The mode may be changed using “UP” or “DOWN”and pressing “SET”.
LF= OFF New linefeed setting
8.11.4 IEEE-488 Parameters
The calibrator may optionally be fittedwith an IEEE-488 GPIB interface. In
this case the user may set the interfaceaddress within the IEEE-488 parameter
menu. This menu does notappear on instruments not fitted with the interface.
The menu isindicated by,
IEEE IEEE-488 parameters menu
Press “SET” to enter themenu.
8.11.4.1 IEEE-488 Address
The IEEE-488 interfacemust be configured to use the same address as the ex-
ternal communicating device.The address is indicated by,
AddrESS IEEE-488 interface address
Press “SET” to access the address setting.
Add= 22 Current IEEE-488 interface address
Adjust the valuewith “UP” or “DOWN” and then use “SET” to set the address
to the displayed value.
Add= 15 New IEEE-488 interface address
8.11.4.2 Termination
The nextparamater in the menu is the transmission termination character selec-
tion. The parameter is indicated on thed isplay by “EOS”. Itcan be set to car-
riage return only (Cr), linefeed only (LF), or carriage return and linefeed.
Regardlessof the option selected the instrument interprets either a carriage re-
turn or linefeed as a command terminationduring reception.
9105/9107 41
8Controller Operation