Flymo 350/400 manual Preparation

7.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.

8.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a dam- aged cable, replace it with a new one. Use only Flymo replacement cable.

9.Always wind cable carefully, avoiding kinking.

10.Never carry the product by the cable.

11.Never pull on the cable to disconnect any of the plugs.

12.Use only on AC mains supply voltage shown on the product rating label.

13.Flymo products are double insulated to EN60335. Under no circumstances should an earth be con-

nected to any part of the product.

Preparation

1.While using your product always wear substantial footwear and long trousers.

2.Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade.

3.Before using the machine and after any impact, check for signs of wear or damage and repair as necessary.

4.Replace worn or damaged blades together with

their fixings in sets to preserve balance.

Use

1.Use the lawnmower only in daylight or good artifi- cial light.

2.Avoid operating your lawnmower in wet grass, where feasible.

3.Take care in wet grass, you may lose your footing.

4.On slopes, be extra careful of your footing and wear non-slip footwear.

5.Mow across the face of slopes, never up and down.

6.Exercise extreme caution when changing direction on slopes. Walk never run.

7.Mowing on banks and slopes can be dangerous. Do not mow on banks or steep slopes.

8.Do not walk backwards when mowing, you could trip.

9.Never cut grass by pulling the mower towards you.

10.Switch off before pushing the mower over sur- faces other than grass.

11.Never operate the lawnmower with damaged guards or without guards in place.

12.Keep hands and feet away from the cutting means at all times and especially when switching on the motor.

13.Do not tilt lawnmower when the motor is running, except when starting and stopping. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Always ensure that both hands are in the operat- ing position before returning the appliance to the ground.

14.Never pick up or carry a mower when it is operat- ing or still connected to the mains supply.

15.Remove the plug from the mains :

- before leaving the mower unattended for any peri- od;

-before clearing a blockage;

-before checking, cleaning or working on the appli- ance;

-if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition.;

-if the lawnmower starts to vibrate abnormally. Check immediately. Excessive vibration can

cause injury.

Maintenance and storage

1.Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition.

2.Replace worn or damaged parts for safety.

3.Only use the replacement blade, blade bolt, spac- ers and impeller specified for this product.

4.Be careful during adjustment of the lawnmower to prevent entrapment of the fingers between moving blades and fixed parts of the machine.

CABLES		MAINS PLUG REPLACEMENT
IMPORTANT		IMPORTANT
•	Use only 1.00mm2 size cable up to 40 metres	•		If the plug supplied is cut off it should be
	length maximum.			destroyed. There is an electric shock hazard if
Maximum rating :				a cut off plug is inserted into a 13 amp socket.
1.00mm2 size cable, 10 amps 250 volts AC.		1.		No earth required. Flymo products are double
•	THE TURBO LITE 330 IS SUPPLIED WITH			insulated to EN60335 and under no circum-
	CABLE WIRED DIRECTLY INTO THE PROD-			stances should an earth be connected to any part
	UCT.			of the product.
•	THE TURBO LITE 350/400 IS SUPPLIED WITH	2.		Ensure the mains voltage suits your product
	AN ELECTRIC MAINS CABLE FITTED WITH A	3.		IMPORTANT!
	FEMALE CONNECTOR			The wires in the mains lead are coloured in accor-
1.	Flymo Mains Cables and Extension Cables are			dance with the following code:
	available from your local Electrolux Outdoor			BLUE	-	NEUTRAL
	Products Approved Service Centre.			BROWN	-	LIVE
2.	Do not wire an extension cable directly to your			The wire which is coloured BLUE must be con-
	product yourself. Please contact your local			nected to the Terminal which is marked with the
	Electrolux Outdoor Products Approved Service			letter 'N' or coloured BLACK.
	Centre for further information on the connectors			The wire which is coloured BROWN must be con-
	and kits available.			nected to the Terminal which is marked with the
3.	Only use extension cables specifically designed			letter 'L' or coloured RED.
	for outdoor use.	4.		It is important that the outer sheath is clamped
CONNECTORS				correctly into the 3-pin plug.
IMPORTANT		5.		If in doubt consult your local Service Repairer or
•	Flymo connectors are suitable for use with 2 core			qualified electrician before the machine is used.
	cable only. Under no circumstances should these	6.		A 13 Amp fuse must be fitted to the Mains Plug.
	connectors be used for earthed products.	7.		The normal plug fuse and household fuse only
•	All Flymo connectors and cables are of splash-			protect the electrical equipment and are not a
	proof construction. They are not waterproof and			safeguard against electrocution.
	must not be left outside permanently nor should
	they be submerged or immersed in water. Do not		If your product is hard wired i.e. non-detachable
			mains electric cable, a conversion kit and exten-
	let cable lay or trail through pools of water or
			sion cable is available from all Electrolux Outdoor
	splashed with water from hose pipes.
			Products Approved Service Centres which can be
			found in your local Yellow Pages.