Assembly
A
lower handle
slots
fixing pin
B |
|
| |
1 | button |
| |
2 |
|
| 3 |
Fitting the Lower Handles to Your Lawnmower (A)
1.Place the end of the lower handle into the slots.
2.Secure lower handles to hood by firmly pushing fix- ing pin through holes in hood and handle.
3.Repeat on the other side.
•NOTE
Should a problem occur when securing handle to hood with the fixing pin, carefully lever fixing pin out of location and repeat steps 1 to 3 above.
Fitting Upper Handles to Lower Handles (B)
1.Ensure the upper handle is located correctly with the
2.Ensure the upper handle and the lower handle are aligned correctly.
3.Insert the nut into the handle knob (B1).
4.Fit the bolts, washers and handle knobs (B2).
5.Fit the cable to the handles with the clips provided.
Make sure the cable is not trapped between the upper and lower handles (B3).
Handle Adjustment
C
PULL
LOWER 
HANDLE
•WARNING! STOP THE LAWNMOWER AND WAIT UNTIL THE BLADE HAS STOPPED ROTAT- ING BEFORE ADJUSTING THE HANDLE.
•NOTE! REMOVAL OF LOWER HANDLE FIXING PINS IS NOT REQUIRED TO ADJUST THE HAN- DLE
TO ADJUST THE HANDLE (C)
1.Hold handle as illustrated.
2.Take the weight of the handle with your right hand...
3....then grip the lower part of the handle with your left hand...
4....and pull the lower handle towards you with your left hand.
5.Move to forward or down position as required.
HANDLE IN FORWARD POSITION
Follow procedure described in "TO ADJUST THE HAN- DLE" and push handle forward until it stops.
HANDLE IN DOWN POSITION
Follow procedure described in "TO ADJUST THE HAN- DLE" and move handle downward until it stops.. NOTE -
The handle does not rest flat on the ground.
HANDLE IN OPERATING POSITION
Adjustment is not required to move the handle to the operating position
Simply pull down from the forward position or lift up from the down position until the handle is in the most comfort- able operating position.
