Safety
WARNING. When using the machine the safety rules must be followed. For your own safety and that of bystanders please read these instructions before operating the machine. Please keep the instructions safe for later use.
Explanation of Symbols on your product
Warning
The use of eye protection is recommended to protect against objects thrown by the cutting parts.
Read the user instructions carefully to make sure you understand all the controls and what they do.
10m | Keep bystanders away. Do not operate |
| whilst people especially children or pets |
| are in the area. |
Do not operate in the rain or leave the product outdoors while it is raining.
Switch off! Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged.
Warning
The cutting line continues to rotate after the machine has been switched off.
General
1.This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the product by a person responsible for their safety. Children should be supervised to ensure that they do not play with the product. Local regulations may restrict the age of the operator.
2.Never allow children or people unfamiliar with the instructions to use the machine.
3.Stop using the machine while people, especially children, or pets are nearby.
4.Only use the product in the manner and for the functions described in these instructions.
5.Never operate the product when you are tired, ill or under the influence of alcohol, drugs or medicine.
6.The operator or user is responsible for accidents or hazards occurring to other people or their property.
7.Keep bystanders away. Do not operate whilst people, especially children or pets are in the area.
Electrical
AVOID ACCIDENTAL STARTING, REMOVE PLUG FROM MAINS AND KEEP FEET AWAY FROM THE SWITCH LEVER WHEN:- CLEANING AROUND THE INSIDE OF THE SAFETY GUARD, REMOVING OR REFITTING SPOOL CAP, MANUALLY FEEDING OR REPLACING NYLON LINE
1.The use of a Residual Current Device (R.C.D.) with a tripping current of not more than 30mA is recommended. Even with a R.C.D. installed 100% safety cannot be guaranteed and safe working practice must be followed at all times. Check your R.C.D. every time you use it.
2.Before use, examine cable for damage, replace it if there are signs of damage or ageing.
3.Do not use the product if the electric cables are damaged or worn.
4.Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.
5.Your extension cable must be uncoiled or unwound, coiled or wound cables can overheat and reduce the efficiency of your mower.
6.Keep the cable clear of the cutting area and obstacles at all times.
7.Do not pull cable around sharp objects.
8.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.
9.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only Flymo replacement cable.
10.Always wind cable carefully, avoiding kinking.
11.Never carry the product by the cable.
12.Never pull on the cable to disconnect any of the plugs.
13.Use only on AC mains supply voltage shown on the product rating label.
14.Our products are double insulated to EN60335. Under no circumstance should an earth be connected to any part of the product.
Cables
Use only 1.00mm2 size cable up to 40 metres length maximum.
Maximum rating:
1.00mm2 size cable 10 amps 250 volts AC
1.Mains cables and extensions are available from your local Husqvarna UK Ltd. Approved Service Centre.
2.Only use extension cables specifically designed for outdoor use.
Preparation
1.While using your product always wear substantial footwear and long trousers.
2.Before using the machine and after any impact, check for signs of wear or damage and repair as necessary.
3.Inspect the area to be cut before each use. Remove all objects such as stones, broken glass, nails, wire, string etc, which can be thrown or become entangled in the trimmer head.
4.Check that the cutting head, spool and cap are fitted correctly.
Use
1.Use the trimmer only in daylight or good artificial light.
2.Avoid operating your trimmer in wet grass, where feasible.
3.Take care in wet grass, you may lose your footing.
4.On slopes, be extra careful of your footing and wear
5.Do not walk backwards when trimming, you could trip. Walk, never run.
6.Never operate the trimmer with damaged guards or without guards in place.
7.Never fit metal cutting elements.
8.Keep hands and feet away from the cutting means at all times and especially when switching on the motor.
9.Keep cutting head below waist level.
10.Do not lean over the trimmer guard whilst trimming or edging - objects may be thrown by the cutting line.
11.Beware of
