Battery
Battery Care
1.If over a period of time the battery quickly runs down after a full 24 hour charging period, a replacement battery is needed.
2.There will be some charge present in the battery but to ensure maximum running time, recharge your trimmer for 24 hours before use.
3.Permanent connection to the charger in a well ventilated area will automatically keep your battery fully charged ready for use.
4.To prevent permanent battery damage, never store in a discharged condition.
5.Contact your local approved service centre/dealer/distributor for a replacement battery and for safe disposal of your old battery.
6.Battery
12 Volt 7 Amp/Hour | "High Power" |
Sealed for Life | No maintenance |
required |
|
•IMPORTANT
DISPOSE OF YOUR OLD BATTERIES SAFELY
DO NOT CUT OPEN, BURN OR INCINERATE.
Battery Replacement
Should your battery need to be replaced contact your local approved service centre or dealer who will remove your old battery and fit a genuine Flymo replacement battery.
IMPORTANT
The red lead should always be connected to the red terminal on the battery. The black lead should always be connected to the black terminal on the battery.
Bench Top
The wall bracket can also be used as a "bench top" stand for
Winter Storage
1.Fully charge for 24 hours before winter storage.
2.If you are unable to leave your cordless trimmer on permanent charge,
3.Avoid extended storage without
4.Store in a cool dry place.
Fitting the Wall Bracket - Charging the Battery
•IMPORTANT !
Switch charger off at the wall socket before connecting or disconnecting the trimmer to the wall bracket.
1.It is recommended that the wall bracket (F2) should be mounted on a smooth, vertical and internal wall which is strong enough to hold the weight of the product, in a well ventilated area between 5°C and 25°C.
2.There are 3 holes on the wall bracket.
Position the wall bracket with the two holes at the top. See Fig G.
3.Ensure that when the trimmer is attached the bottom of the trimmer is within 4 inches (100 mm) of the ground, this will make it easier to hang the trimmer and will also ensure that the wall bracket is within easy reach of an electric socket to allow the charger to be plugged in.
4.Fix wall bracket securely to the wall with the plugs and screws provided.
5.Your cordless trimmer can now be attached to
the wall bracket for charging.
Initial Charging Procedure
1.Use the charger indoors only.
2.Ensure the charger is not exposed to moisture. Keep the charger and the trimmer dry at all times. Keep the charger well ventilated during charging.
3.Ensure the product is correctly located into the wall bracket (F2) and the charge connector
(G1).
4.Plug the charger (F1) into a suitable household electrical wall socket and switch on.
5.The red indicator lamps (F3, F4) glow
continuously during charging.
•The red indicator lamp on the product (F3) is a power indicator and will continue to glow
red even when the battery is fully charged.
6.Full charge will be achieved in 24 hours after which the indicator lamp on the charger (F4) will turn to green. During charging the charger
becomes warm. This is normal and means the charger is operating correctly.
Re-Charging Your Product
1.
2.Avoid running the product into "deep" discharge, i.e. avoid flattening the battery completely.
3.Follow the procedure outlined in the Initial
Charging Procedure.
4.Charging the battery according to these instructions should ensure maximum battery life.
•The charger will automatically keep the battery topped up with charge during storage and will ensure that the cordless trimmer is ready for use.
•The battery should be charged for 24 hours before use.
•
•The cordless trimmer can be left connected to the charger permanently, with the charger switched on, without fear of overcharging.
ENGLISH - 2
