9
Nylon Line
To manually feed the nylon line
If required, line can be fed out manually. To operate, gently pull on the line whilst at the same time alternately pressing and releasing the button, on the side of the spoolholder. See fig V.
To replace nylon line. Replacement nylon line is available from most Flymo/Partner stockists. You can buy it either as spool and line complete, or as nylon line only.
To replace spool and line (complete)
V |
Do not depress the button more than three times. Excessive line will snag the line cutter and cause the trimmer to malfunction.
1.Take new spool and remove tape holding line in place.
2.Unwind approximately 100mm of line and feed this through eyelet, see fig W, then drop the spool into spoolholder smooth side uppermost.
To replace nylon line on spool.
1. | Take line and insert into hole in spool. |
2. | Turn spool clockwise to wind on required |
| amount of line, (approx. half = 10m) and |
| cut line to length, see fig X. Care should |
| be taken to ensure that the line is neatly |
W |
eyelet |
X |
| |
hole in | line | |
spool | ||
|
coiled on the spool. Failure to do so will |
impair the efficiency of the automatic line |
feed. |
3. Leave approximately 100mm of line |
unwound and feed this through eyelet, see |
fig W, then drop the spool into the |
spoolholder smooth side uppermost. |
•Ensure spool is fully located by gently rotating it during fitment.
•Remember! Your Flymo Cordless Trimmer is designed to use only nylon line with a maximum diameter of 1.5mm. Use only genuine Flymo nylon line.
Caring for your Cordless Trimmer
After you have finished using your Flymo trimmer follow the procedure below:
1.Never clean your trimmer with water, cleaning fluids, or solvents, just remove debris with a suitable tool, a soft brush or dry cloth.
2.Using the scraper provided, clean around the inside of the safety guard to remove any grass and debris. (Fig Y1)
3.Using a soft brush, clean around the inside of the safety guard (Fig Y2), the cutting head (Fig Y3) and the motor housing. (Fig
Y4)
4.Inspect the trimmer carefully, especially the parts of the cutting head.
5.If your trimmer is damaged in any way contact your local Flymo/Partner approved service centre.
•Never use a damaged trimmer
6.Wind cable carefully to avoid kinking.
7.Store in a cool, dry place and out of reach of children.
Y | 1 | 2 |
| |
| 3 | 4 |
| |
• Avoid accidental starting. Keep your hands | MAINTENANCE | |||
| and fingers away from the switch lever while | |||
| inspecting, cleaning or carrying out any | |||
| maintenance work. |
| ||
• Keep fingers and hands clear of line cutter on | ||||
| ||||
| leading edge of guard. |
|
| |
