Double Auto Feed System
G
line cutter
How the automatic line feed works (G)
1.When initially switching on the trimmer, a small length of line is fed out.
2.A ‘clattering’ noise will be heard when the two nylon lines hit the line cutter. DO NOT BE ALARMED this is quite normal. After approximately 5 seconds the line will be cut to the correct length and the noise will
reduce as the motor reaches full speed.
•Make sure the motor is up to full speed before trimming or edging.
3.If the noise of the nylon line being cut cannot be heard, more line will need to be fed out.
4.To feed more line, it is first necessary to to allow the motor to stop completely, then
5.Repeat step 4. until you hear the lines hitting against the cutter. (Do not repeat this procedure more than 6 times)
6.If problems are experienced with the automatic line feed refer to Fault Finding Chart.
How to trim and edge
H |
K |
J |
•WARNING
•The use of eye protection is recommended.
Do not lean over the trimmer whilst trimming or edging, objects may be thrown by the cutting line.
Do not allow cutting head to rest on the ground. Do not overload your trimmer.
Overloading can be avoided by making sure the motor speed does not drop unduly.
DISCONNECT FROM THE MAINS ELECTRICITY SUPPLY BEFORE ATTEMPTING ANY MAINTE- NANCE OR ADJUSTMENT.
•BEFORE USE
Make sure that both lines are fed out.
•Make sure motor is up to full speed before trim- ming or edging.
How to trim
1.Hold as illustrated in Fig H.
2.To start, squeeze the switch lever.
3.Cut with nylon line at an angle using the tip. See Fig
J.
4.Swing trimmer in and out of the cutting area taking small cuts (K)
5.Line is fed out automatically every time the trimmer head stops rotating and returns to operating speed.
L |
2 |
1 |
M |
1 |
•Extra line can be fed out manually as described in
Manual line feed
6. To stop your trimmer release the switch lever.
How to edge
1.To convert to edging mode, press button (L1) and twist head (L2). An audible "click" will confirm that the head is locked.
2.Hold as illustrated in Fig H.
3.To start, squeeze the switch lever.
4.Rest edger on wheel for extra stability and line up the
edge of the lawn with the two indicators on the guard (M1). Edge in direction indicated in Fig M.
5.To stop your trimmer release the switch lever.
6.To return to trimming mode, press button and twist head back the opposite way. An audible "click" will confirm that the head is locked.
