www.fmiproducts.com
113111-01 11
IMPORTANT: When nishing your rebox,
combustible materials
WARNING: Do not allow any combustible/noncombustible materials to overlap the rebox front facing. WARNING: Do not allow noncombustible materials to cover any necessary openings like louvered slots. WARNING: If pre-wiring, do not connect wiring to any electri-cal source at this time.Install replace electrical outlet and connect wiring to outlet before connecting to electrical source. The replace electri-cal outlet is included with the GA3450T blower accessory.Only use the replace electri-cal outlet supplied with the GA3450TA blower accessory.2. If installing GA3450TA blower accessory,
do so at this time. See Installing Blower
Accessory GA3450TA, page 13.
Note: If not installing blower accessory,
you may wish to run electrical wiring to
your replace for future blower installa-
tion (see Accessories, page 29) Use only
approved three-wire electrical wiring.
Note: A qualied installer should make all
electrical connections.
3. Install gas piping to replace location. This
installation includes an approved exible
gas line (if allowed by local codes) after
the equipment shutoff valve. The exible
gas line must be the last item installed on
the gas piping.
4. If you have not assembled rebox, follow
instructions on page 4.
5. Carefully set replace in front of rough
opening with back of replace inside wall
opening.
6. Attach exible gas line to replace gas
regulator. See Connecting to Gas Supply,
page 16.
7. Bend four nailing anges on outer casing
with pliers (see Figure 10).
8. Attach replace to wall studs using nails
or wood screws through holes in nailing
ange.
9. Check all gas connections for leaks. See
Checking Gas Connections, page 18.
10. If using optional trim kit, install the trim
after nal nishing and/or painting of wall.
See instructions included with trim acces-
sory for attaching trim.
InsTallaTIon
Continued
36
5/8
"
25
7/8
"
51
3/4
"
26
7/8
"
Figure 9 - Rough Opening for Installing
in Corner
26
7
/
8
"
26
7
/
8
"
3/4" Off
The Floo
r
Minimum
10
1
/
2
"
Figure 8 - Rough Opening for Installing
in Wall
Figure 10 - Attaching Fireplace to Wall
Studs
Nails or
Wood
Screws
Nailing
Flanges