www.fmiproducts.com
113111-01 5
PRodUCT FeaTUResasseMBly
Figure 2 - Assembling Fireplace
Log
Screen
Burner Support
with Log
Locator Tabs
Branch
Support
Shoulder
Screw

SAFETY PILOT

This replace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room replaces. The ODS/pilot
shuts off the replace if there is not enough
fresh air.

PIEzO IGNITION SYSTEM

This replace has a piezo ignitor. This sys-
tem requires no matches, batteries, or other
sources to light replace.

THERMOSTATIC HEAT CONTROL

This replace has a thermostat sensing bulb
and a control valve. The thermostat will auto-
matically modulate the heat output to maintain
a consistent room temperature. This results in
greater replace comfort. This can also result
in lower gas bills.
UnPaCkIng
1. Remove replace and hood from carton.
Log is wrapped and inside replace. Do
not remove at this time.
2. Remove all protective packaging applied
to replace for shipment.
3. Make sure your replace includes one
hardware packet.
4. Check replace for any shipping damage.
If heater is damaged call FMI PRODUCTS,
LLC at 1-866-328-4537 for replacement
parts before returning to dealer.

WARNIN G: Always have

branch support and screen in

place before operating replace.

This prevents excessive temper-

atures on replace surfaces.

WARNING: Failure to position

the parts in accordance with these

diagrams or failure to use only

parts specically approved with

this replace may result in prop-

erty damage or personal injury.

ASSEMBLING FIREPLACE

Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
Installing Log
1. Lift screen up and pull out to remove.
2. Cut two plastic straps to remove the log
from the rebox cavity.
3. An optional blower is available. See Ac-
cessories, page 29. Install optional blower
now. Follow installation instructions pro-
vided with blower.
4. Remove log packaging material and
discard packaging. Gently place log set
on burner support (see Figure 2). The log
should t at against top of burner sup-
port and log locator tabs t into the slots
under the log. Do not allow log to contact
ame. If ame contacts log, soot will be
created.
5. Reattach screen by placing the notches
in the screen frame over the shoulder
screws and pushing down.