OPERATION

Continued

7.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner.

If needed, keep ignitor button pressed in until pilot lights.

Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure.

8.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob.

•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.

Note: If pilot goes out, repeat steps 4 through 8.

9.Slightly push in and turn control knob

counterclockwise to the ON position.

10.Wait one minute and switch selector switch to the ON position to light burners (see Figure 30). When using in the ON position (without remote) burners will light on high. There is no adjustment to the flames without using remote.

11.To leave pilot lit and shut off burners only,

turn control knob clockwise to the

PILOT position, or use remote control manual OFF button, or set selector switch in the OFF position.

WARNING: Make sure the selector switchisintheOFFposition whenyouareawayfromhomefor long periods of time. Heater will comeonautomaticallywithselector switch in the ON position.

Pilot

Ignitor

Pilot

Ignitor

Burner

Electrode

Burner

Electrode

Figure 31 - Pilot

Figure 32 - Pilot

(Natural)

(Propane/LP)

TO TURN OFF GAS

TO APPLIANCE

1.Turn control knob clockwise to the OFF position.

2.Set selector switch in the OFF position.

3.Close equipment shutoff valve (see Figure 18, page 16).

MANUAL LIGHTING

PROCEDURE

1.Follow steps 1 through 6 under Lighting Instructions, page 20.

2.Depress control knob and light pilot with match.

3.Keep control knob pressed in for 30 sec- onds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11 under Lighting Instructions.

BLOWER

OPERATION

WARNING: This fireplace has athree-prong,groundedelectrical plug. This plug helps protect you againstelectricalshock.Onlyconnect plug to a properly grounded, three-prongreceptacle.Donotcut or remove the grounding prong from this plug.

ON REMOTE OFF

PRG

Figure 30 - Remote Selector Switch in

ON Position

Locate the blower switch by opening lower louver on fireplace. Blower switch is located at lower center inside louver door.

Note: It is safe to operate fireplace with blower

turned off. However, the blower helps distribute

heated air from the fireplace.

Note: Periodically check the louvers of the

firebox and remove any dust, dirt or other

obstructions.

121082-01K

www.fmiproducts.com

21