6.Fireplace with louver door: Lower bottom louver door. Use two screws provided in hardware package and attach fire- place to wooden base (see Figure 10). Close louver door
Fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws securing floor to assembly. Lift floor for access to bottom of fireplace. Use two screws provided in fireplace hardware package and attach fireplace base to wooden base (see Figure 11). Reinstall floor with screws removed previously.
7.Place metal trim on shoulder screws. Firmly snap trim assembly over shoulder screws on fireplace.
8.Carefully push mantel and base into position against wall.
Bottom
Louver Door
Hole for Attaching
Fireplace System to
Wooden Mantel Base
Figure 10 - Attaching Fireplace to Mantel and Mantel Base
Screws |
Fixed | Holes are Behind Louver on |
Louver | Fireplace Bottom for Attaching |
| Fireplace to Wooden Mantel |
| Base. |
Figure 11 - Screw Locations for Fireplaces with Fixed Louver
Installing Fireplace without Flange
1.Place mantel assembly on wood base and center left to right having back of assembly flush with back of base.
2.Attach mantel to base using 1 1/4" screws through pocket holes. Using brackets and 1/2" or 3/4" screws from bracket hardware kit, attach brackets to base and mantel assembly using one bracket at each back corner of leg sides and one on each leg front (see Figure 9, page 3).
3.Position fireplace inside mantel (see Figure 12). Care- fully position gas lines. Important: Use caution when positioning fireplace on base. Base may scratch easily.
4.Fireplace with louver door: Lower bottom louver door. Use two screws provided in hardware package and attach fireplace to wooden base (see Figure 10). Close louver door
Fireplace with fixed louver: Before installing logs or burner assembly (see owner’s manual) remove screws secur- ing floor to assembly. Lift floor for access to bottom of fireplace. Use two screws provided in fireplace hardware package and attach fireplace base to wooden base (see Figure 11). Reinstall floor with screws removed previ- ously.
5.Place metal trim on shoulder screws. Firmly snap trim assembly over shoulder screws on fireplace.
6.Carefully push mantel and base into position against wall.
(Side view for clarity)
Shoulder Screw
Mantel Possible
Base Shutoff
Valve
Locations
Assembled | Shoulder |
Metal Trim | Screws |
Figure 12 - Installing Fireplace without Flange
2701 Industrial Drive
P.O. Box 90004
Bowling Green, KY
Technical Service and Parts
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
| 119360 01 |
|
|
|
|
|
|
|
| Rev. B | ||||||||
| NOT A UPC |
|
|
|
|
| ||||||||||||
| 07/06 | |||||||||||||||||
