FortiGate-5001FA2-LENC Security System Guide
26 01-30000-76602-20080606
Configuring NAT/Route mode Quick Configuration Guide
3Set the addressing mode for the interface. (See the online help for information.)
• For manual addressing, enter the IP address and netmask for the interface that
you added to Table6 on page 25.
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE and enter the username and password
and any other required settings.
To configure the Primary and Secondary DNS server IP addresses
1Go to System > Network > Options.
2Enter the Primary and Secondary DNS IP addresses that you added to Table 6 on
page 25 as required and select Apply.
To configure the Default Gateway
1Go to Router > Static and select Edit icon for the static route.
2Select the Device that you recorded above.
3Set Gateway to the Default Gateway IP address that you added to Tabl e 6 o n
page 25.
4Select OK.
Using the CLI to configure NAT/Route mode
1Use the serial cable supplied with your FortiGate-5001FA2-LENC board to
connect the FortiGate Console port to the management computer serial port.
2Start a terminal emulation program (HyperTerminal) on the management
computer. Use these settings:
Baud Rate (bps) 9600, Data bits 8, Parity None, Stop bits 1, and Flow Control
None.
3At the Login: prompt, type admin and press Enter twice (no password required).
4Change the administrator password.
config system admin
edit admin
set password <password>
end
5Configure the port1 internal interface to the setting that you added to Table6 on
page 25.
config system interface
edit port1
set ip <intf_ip>/<netmask_ip>
end
6Repeat to configure each interface as required, for example, to configure the port2
interface to the setting that you added to Table6 on page 25.
config system interface
edit port2
...