Fortinet 60B manual Using the CLI, For details, see the FortiGate Administration Guide

Configuring Configuring NAT mode

3Set the following and select OK.

Source Interface	Select the port connected to the Internet.
Source Address	All

Destination Interface Select the port connected to the network.

Destination Address All

Schedulealways

ServiceAny

ActionAccept

Firewall policy configuration is the same in NAT/Route mode and Transparent mode.

Note that these policies allow all traffic through. No protection profiles have been applied. Ensure you create additional firewall policies to accommodate your network requirements.

For details, see the FortiGate Administration Guide.

Using the CLI

After connecting to the CLI, you can use the following procedures to complete the basic configuration of the FortiGate unit. Ensure you read the section “Connecting to the CLI” on page 17 before beginning.

Configure the interfaces

When shipped, the FortiGate unit has a default address of 192.168.1.99 and a netmask of 255.255.255.0. for either the Port 1 or Internal interface. You need to configure this and other ports for use on your network.

To set an interface to use a static address

config system interface edit <interface_name>

set mode static

set ip <address_ip> <netmask>

end

To set an interface to use DHCP addressing

config system interface edit external

set mode dhcp

set distance <integer>

set defaultgw {enable disable}

set dns-server-override {enable disable}

end

FortiGate-60B FortiOS 3.0 MR6 Install Guide
01-30006-0446-20080910	21