|
|
New features and changes | SNMP MIBs and traps changes |
Upgrading the HA cluster for FortiOS 3.0
The following procedure will help you upgrade a FortiOS 2.80 HA cluster to
FortiOS 3.0.
You can use either the
CLI command and a TFTP server to upgrade the cluster.
To upgrade the cluster
1Backup the configurations of the primary unit. See “Backing up your configuration” on page 33.
2Install the firmware image on the primary unit.
This may take a few minutes since the primary unit will upgrade the subordinate units as well. The FortiGate units in the cluster will reboot once or twice during the upgrade.
Note: The primary/subordinate roles may change during the upgrade, if HA override is not enabled before upgrading.
SNMP MIBs and traps changes
In FortiOS 3.0 the trap file is combined into the MIB file - there is only one MIB file to download and install to your SNMP management system.
SNMP traps and variables that used hyphens (for example
The v3.0 MIB file also has more
In-depth SNMP trap changes
The following table displays trap name changes, including additional trap names for FortiOS 3.0.
FortiOS v3.0 trap name / status | FortiOS v2.8 trap name / status |
|
|
fnFMTrapIfChange | New |
fnFMTrapConfChange | New |
No longer available | fnTrapHaStateChange |
No longer available | fnTrapIdsPortScan |
No longer available | fnTrapImTableFull |
In-depth MIB file name changes
The following table displays trap name changes, including additional trap names for FortiOS 3.0.
Location | FortiOS v3.0 | FortiOS v2.8 |
| trap name / status | trap name / status |
|
|
|
System | fnSysDiskCapacity | New |
| fnSysDiskUsage | New |
Upgrade Guide for FortiOS v3.0 | 31 |