Foster 7372 241 Automatic safety off, Indication of the heater on timer, Timer Countdown End

timer can only operate on one heater each time.

The heater must always be selected (the display must be viewed “0”) before the time is set; otherwise, the timer will switch off.

If we take longer than 10 seconds to select the heater, the timer will switch off. If, after selecting the heater, the time is not defined (T=00) in 5 sec., the timer switches off.

When the timer value runs out, the heater associated with the timer switches off.

Indication of the heater on timer

The touch control indicates the heater on which the timer is operating. This indication consists of a LED next to the heater display.

This option reminds the user at all times that the heater is on timer.

Increasing the value of the timer

If the sensor (+) or (-) associated with the timer is held down, The value increases/decreases automatically. This makes it possible to reach the desired timer setting more quickly. From the tenth consecutive increase/decrease of the timer setting, the speed at which the value changes increases.

Timer Countdown End

The countdown begins 5 seconds after the last operation on the keys (+ and -) of the timer (E). You will hear an acoustic signal, and timer's display and the LED of the zone where you have activated the timer stop flashing.

The last minute will be displayed in seconds.

Switching the timer off

To cancel the operation of the timer, select a timer value of <00> using the sensor (-), or switch off the timer by pressing the corresponding sensors (E+ and E-).

Duration of the alarm

When the time set on the timer has run out, a beep sounds for 1 minute. After 1 minute from when the timer alarm starts, the beep stops. The timer displays continue to flash with the indication <00>. The alarm can be cancelled by the user at any time, even during the first minute of the alarm, by pressing any sensor on the touch control.

ATTENTION: The timer can also be set up for a cooking zone that is at the level "0", LED will remain flashing all the time of the countdown. In this case the timer can have alarm function.

Automatic safety off	If the power level is not changed during a preset time, the corresponding heater
	turns off automatically.
	The maximum time a heater can stay on depends on the selected cooking level.
		Level	1	2	3	4	5	6	7	8	9
		Max. time on (hours)	10	10	10	10	10	10	10	10	3

Uninterrupted operation at every power level of each cooking zone is limited in time (see the table above). When the cooking zone turns off by the safety mechanism, the display shows the symbol "0" or "H", if there is residual heat.

The cooking zone can be turned off by the sensor (A-) for setting the level cooking.

Example:

Set the hotplate to power level 5 and let it operate for some time. If you don’t

27