Installation procedure • Worktop must be placed absolutely horizontal.
•Suitably protect the edges of the cut aperture.
•Connect the cooking hob to the mains power supply (see instructions for the connection of the cooking hob to mains power supply).
•Insert the hob into the cut aperture.
•Press the hob firmly towards the worktop from above.
CONNECTION TO THE POWER SUPPLY
Basic adjustment of sensors to the ambience
Installation diagram
•Connections may be carried out by a qualified technician only. The earthing protection must comply with the standing regulations.
•Connection terminals are revealed when the connection box cover is removed.
•Prior any attempted connection check that the voltage indicated on the rating plate is in line with your home power supply.
•The rating plate is located underneath the appliance.
•The appliance is manufactured for use with the power supply voltage
•The electric wiring should be equipped with a circuit breaker able to isolate the appliance from the mains in all points, with the distance between terminals of at least 3 mm in open position. This may be done by means of fuses, safety switches, etc.
•The connection should be selected in accordance with the declared charge capacity of the mains and the fuse power.
•Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the height of which may exceed that of the appliance. On the opposite side however, only a kitchen cabinet of equal height as the appliance is allowed.
•Upon the completion of installation, live wires and isolated cables must be adequately protected against accidental touching.
Upon each connection to the power supply the sensors of the appliance are automatically adjusted to the environment to ensure their proper function. All displays turn on and are fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise the adjustment procedure will be interrupted until such objects are removed from the sensor surface. During this period the regulation of the cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance, disconnect the power supply. In accordance with the mains voltage the appliance should be connected in line with the attached diagram.
The earthing wire (PE) must be connected to the terminal marked with the earthing symbol .
The connection cable must lead through the relief safety device, protecting it from accidental pulling out. Upon the completion of installation switch all the hotplates on for about 3 minutes to check the proper functioning.
Connection must be carried out by means of harmonized cables as
22
