Fostex owner manual How to stack the PD-6 and EX12 together

How to stack the PD-6 and EX12 together

1)Remove the blank panel at the bottom of the PD-6.

2)Replace the two screws for fixing the rubber feet at the bottom of the PD-6 with the screws supplied with the EX12.

<Note>: Never forget to replace the screws for fixing the rubber feet. Otherwise, the PD- 6 may malfunction or generate a noise be- cause of imperfect grounding.

3)Remove the two screws for fixing the cover at the top of the PD-6, and open the cover.

<Note>: The removed screws are used later for fixing the cushion. Be sure not to lose them.

4)Fix the supplied cushion using the fixing screws which are removed in the previous step.

Cushion

5)Pull out the connection cable from inside the EX12.

6)Put the PD-6 on the EX12 and plug the connector of the cable to the PD-6, as shown below. Make sure to plug the connector in the correct direction.

5