Fostex owner manual After connecting the cable, stack the PD-6 on the EX12

7)After connecting the cable, stack the PD-6 on the EX12.

<Note>: When stacking the PD-6 on the EX12, make sure to perfectly fit the dent of PD-6 rubber feet to the metallic projections of each EX12. Otherwise, the PD-6 may malfunction or generate a noise because of imperfect grounding.

8)Use the fastenings on both the left and right sides of the EX12 to fastening the PD-6.

Pull up the metallic projection of each fasten- ing and hang it on the PD-6.(The following pic- tures show the example of the left side.)

After hanging the projection on the PD-6, lift up the fixing angle until it is locked.

9)Fasten the fixing screw of each fastening.

Fasten the fixing screw of each fastening so that the fastening may not be off. Be careful not to apply excessive force.

Confirm both the left and right fastenings are fixed tightly.

Now you complete stacking the EX12 and PD-6 together.

The next step is to connect the power cords. See the next page.

6