Fostex PM-1MKII Setup Instructions continued, Back Panel Overview, XLR & TRS Combination Input

Setup Instructions continued

Once the studio monitors have been placed in their final location, it is time to proceed to connecting your PM-1 MKⅡ studio monitors to the mixing console or digital workstation. Connection to the PM-1 MKⅡ can be made using XLR or TRS connectors. The gain control on the back of the monitor allows continuously variable adjustments to match most input types from -10dBV to +4dBu. The input is electronically balanced and is compatible with unbalanced sources, although this may require an adapter. The connection of the PM-1 MKⅡ to the console/digital workstation should be done in the following order.

Step 1: Make sure that all equipment has been powered down.

Step 2: Confirm that all gain controls, on the monitor and the source, are set to the minimum setting.

Step 3: Connect the source to the PM-1 MKⅡ monitor.

Step 4: Power up the all source equipment and then turn on the PM-1 MKⅡ last.

Step 5: Set the gain of both monitors at medium setting and slowly bring up the gain of the console.

Step 6: Adjust the gain of both monitors for balance and for best signal to noise ratio

Once the above steps have been completed, you are ready to use your PM-1 MKⅡ monitors. It is recommended that you now play some familiar audio material and make any final adjustments, as far as placement or level, to get the optimum performance in your monitoring environment.

Back Panel Overview

1. XLR & TRS Combination Input

This input is an electronically balanced input and is compatible with both -10dBV and +4dBu signals.

2. Continuously variable gain control

This control adjusts the input level to the internal amplifiers.

3. Heatsink

The heatsink dissipates heat from the amplifier. It is important the heatsink receives proper ventilation and is not placed near any sources of heat.

4. Power Switch

1

2

3

PM-1 MK

INPUT

MAX

G A I N

OFF

Turns power to the amplifier section on or off. On - position is the spot side.

The apparatus shall be used in an open area.

5. Standard IEC Power Input

This power terminal should be used with a properly grounded three pin power cable, such as the one provide with the product.

4

5

P O W ER

AC IN

WARNING:To reduce the risk of fire or electrical shock, do not expose this equipment to rain or moisture. Do not remove cover.No user serviceable parts inside.Refer servicing to qualified personal.

AVIS: RISQUE DE CHOC ÉLECTRIQUE

NE PAS OUVRIR

p-5