Fostex PM-1MKII specifications Product Specifications, Cable and Wiring Information

Product Specifications

Cabinet Dimensions

215mm (W) × 380mm (H) × 283mm (D) includes heatsink 250mm (D) cabinet only - no heatsink

8.5" (W) × 15" (H) × 11.25" (D) includes heatsink 9 7/8" (D) cabinet only - no heatsink

Net Weight

11 Kg

24.3 Pounds

Gross Weight Per pair (includes all packing material)

12.4Kg

27.3Pounds

Frequency Response

Free-Field Frequency Response : ±2dB 50Hz to 20KHz

Low Frequency Cutoff : 38Hz (-10dB)

High Frequency Cutoff : 23.5kHz (-10dB)

Acoustic Output:

Maximum Short Term SPL: 80 Hz - 3kHz > 105dB SPL 1m

Amplifier Power

High Frequency : 45 Watts

Low Frequency : 75 Watts

Amplifier Distortion

<0.007% THD @ 30 Watts / 8Ohm 20Hz-20kHz

Amplifier Signal to Noise Ratio

>93dB

20Hz - 30kHz Not Weighted

Amplifier Slew Rate

15V/sec

Power Requirements

US : 120VAC~60Hz

EUR/UK : 230VAC~50/60Hz

Power consumption

US: 58 Watts

EUR/UK: 58 Watts

Product improvement may warrant a change of specifications, newer materials or cosmetics, Changes in specifications and features may be made without notice or obligations.

Cable and Wiring Information

Use high-quality, shielded cables to connect your mixing console, workstation or other source to your monitors. Foil-shielded cables, such as Beholden 8451, 8761, or 9501 should do quite well. Other high quality cables are available and those that incorporate better shielding will yield an overall higher noise rejection, lowering your systems susceptibility to external interference. Another important tip to keep in mind when wiring your system is to route all line level cables away from the AC and other power sources, this will reduce the probability of having AC hum emanating from your studio monitors.

		XLR	TRS	RCA
HOT (+)		PIN 2	TIP	TIP
COLD (-)		PIN 3	RING
GROUND	)	PIN 1	SHIELD	SHIELD
SHIELD (

Product Cleaning Instructions

Prior to cleaning the PM-1 MKⅡ monitor the power must be disconnected from the PM-1 MKⅡ monitor. Once the power has been terminated, cleaning can be accomplished using a damp (not wet) cleaning rag. A light common house hold cleaner can also be used, but care must be taken not to use harsh cleaning fluids. Regular dusting or cleaning with a damp rag will keep your product looking new for years.

p-6