13
VF-16
4-5. Offset Display
This mode determines if the offset value against a master machine should be displayed when the VF-16 is working as
a slave machine. If you would like to turn ON the offset display, press the [ENTER/YES] key while in the following
display condition. (The default setting is at “off”.)
Then, turn the jog dial C.W. to change the setting to “ON” and press the [ENTER/YES] key.
This allows to display the offset value when the MTC (Select by [TIME BASE] key.) and REMAIN (Select by [DISP
SEL] key.) are selected. The example below indicates that the offset value is “00H00M00S00F00SF”.
4-5. Initializing Disk
This is the mode to initializes a 3.5” internal E-IDE hard disk drive or an external SCSI drive connected to the SCSI port.
CAUTION 1: If both the external SCSI drive and the internal 3.5” E-IDE hard disk drive are connected at the same
time, the drive currently selected by the SETUP menu “Drive_Sel?” will be initialized.
CAUTION 2: This mode is exclusively designed for our manufacturer. To initialize the disk, use the ERASE function
in the Format SETUP menu instead.
If the [ENTER/YES] key is pressed in the above display condition, the drive name to be initialized (IDE or SCSI) is
displayed and “SURE?” will start blinking.