85
Save/Load of Song data
You can select a load destination program from existing
programs on the current drive as well as "New PGM".
When selecting "New PGM", a new program is created.
*If you load data to a program in which data is
already recorded, the newly loaded data overwrites
the current data track by track. Consequently, on
each overwritten track, the loaded data becomes
valid while the current data is erased.
Use the [JOG] dial to select the program to whichdata is loaded and press the [ENTER/YES] key.
The display shows the screen for selecting tracks to
be loaded.
Select tracks to be loaded.
Use the [CURSOR] keys to move the blinking field
between "From" and "To".
Use the [JOG] dial to set the track number for the
blinking field.
For the "From" field, you can select from 1, 9 and 17.
For the "To" field, you can select from 8, 16 and 24.
For example, if you select "From 1 to 24", data for all
tracks (1 to 24) will be loaded.
After selecting tracks, press the [ENTER/YES] keyagain.
The display shows something like the one below. A
load destination program (existing or new program)
to which the data is loaded and tracks to be loaded
are shown, while "Sure?" blinks.
<Note>

In the above step, if the VF08 does not lock to the

digital signal from the external digital recorder, the

following warning message appears on the display,

showing that the VF08 does not receive a correct S/

PDIF digital signal. So check the cable connection and

the digital output setting of the external digital

recorder.

When the VF08 is locking to the digital input signal,
press the [ENTER/YES] key.
The display shows "Play Start Player!".
Start playback of the external recorder.
After reading the pilot signal recorded when saving
the data, the data starts loading automatically.
When starts loading, the display shows something like
the one below, in which "Wait time" starts counting
down.
Data is loaded in 2-track unit.
While loading, the [TRACK STATUS/TRACK SEL] keys
for channels 1 and 2 flash, while the input levels are
displayed by level meters 1 and 2.
When the data loading is completed, "Completed!"
appears on the screen.
<Note>

If you quit loading before completing, the loaded

data is invalid.

Stop the external recorder.
Press the [EXIT/NO] key (or the [STOP] key)
repeatedly until exiting the setup mode.
To cancel each operation or to return to the previous
screen before pressing the [ENTER/YES] key, press the
[EXIT/NO] key (or the [STOP] key). Each press of the
key returns to the previous screen level and finally exits
the setup mode.
4
5
6
7
8
9
10
Blinking
Blinking