98
SETUP mode
SETUP mode
The SETUP mode of the VF08 offers the “Changing the initial settings” menus, which configure the operating
environment of the VF08, a “Check” menu that enables you to check the number of events for each track, and an
“Execution” menu that executes certain operations, such as save and load and disk formatting. The “Changing the
initial settings” menu include 16 parameters as shown in <Table-1> below. These parameters were set before the
VF08 was shipped from the factory and these values are called the “initial settings.” Modifying these settings allows
you to change the operating environment of the VF08. The “Check” menu provides two parameters “Checking the
number of events” as shown in <Table-2> - “Checking the number of events” and “Checking the current drive
information.”
Also, as shown in <Table-3>, the “Execution” menus include three items: Load PGM, Save PGM, and Disk Format,
which you can execute by selecting the corresponding SETUP menu. This chapter explains how to use the “Changing
the initial settings” menus shown in <Table-1> and the “Check” menu shown in <Table-2>.
For more information on the “Execution” menus, refer to the corresponding pages in the “Reference page” column
in <Table-3>.
<Table-3> “Execution” menu
Execution item Display Refer page Community
Saving song data to an external device Load PGM 80 -
Loading song data from an external device Save PGM 80 -
Formatting an current drive disk Disk Format 18 -
<Table-2> “Check” menu
Check item Display Refer page Community
Check of the event number on the track Number Of Event 108 -
Check of the current drive information Drive Information 109 -
<Table-1> “Changing the initial settings” menu
Parameters Display Default setting Refer page Community
Setting a time signature Signature Set 001BAR 4/4 99
Setting a tempo T empo Set 001BAR 1 120 101
Setting the metronome function Click Off 102
Setting MIDI sync output signal Midi Sync Out MTC 103
Setting an MTC frame rate Frame Rate 25 frame 103
Setting an MTC offset value Mtc Offset 00h 59m 57s 00f 00sf 104
Setting the offset mode Offset Mode ABS 104
Setting the slave mode Slave Mode Off 105
Setting the slave type Slave Type Vari 105
Setting the record protect function Rec Protect Off 106
Setting digital input Digital In Off 107
Setting BAR/BEAT resolution mode Resolution Off 107
Setting the MIDI device ID number Device ID 00 108
Setting the drive Drive Select IDE 109 -
Setting the fader fix mode Fader Fix Off 110
Setting the fader recall mode Fader Recall Off 110
: Modes applicable program by program. They can be saved/loaded.
: Modes applicable to all program. They cannot be saved/loaded.