3-3. Tape Transport Mechanical Data
3-3-1. Reel torque
1) | PLAY mode | Supply: 1.5 ~ 6 |
|
| Takeup: 20 ~ 70 |
2) | FF/REW mode | FF /REW: 60 ~ 120 |
3-3-2. Pinch roller pressure
Pull force | 300 ~ 500 g |
3-4. Tape Travel Check and Adjustment
Using the mirror type cassette, check to see that the tape is running stable between the ERASE and REC/PLAY heads tape guides without weaving. If the tape is not running stable between the guides, erasure and frequency response will be affected or the tape will be damaged by curling. It then becomes necessary to check the guide height, perpendicularity of the head surface, and alignment of the pinch roller in relation to the capstan. In addition to the mirror type cassette, the Head Height and Tape Contact Jig is required. To check the head guide height, the cassette tape is removed and the above jig is placed on the head mount base plate. While firmly seating the jig on the base plate surface, slide the jig past each head guide to see that it goes through without hitting them. Also check perpendicularity of each head surface, using the rear check bar of the jig. If the guide is low, insert the required amount of 0.1 mm or 0.2 mm thick washers under the head mounting legs, or vice versa, if it is high.
NOTE: Always adjust the head azimuth and phase when the head height is adjusted.
3-5. Volume & SW setting
Input fader | At 8 ± 1 position |
Master fader | At 8 ± 1 position |
Pan | Fully CCW (L) or CW (R) position |
3-6. Check and Adjusting of Head Azimuth
1)Switch off the DOLBY SW.
2)Connect an AC volt meter to the TAPE OUT and playback the 12.5 kHz section on the
3)Rotate the REC/PLAY head azimuth adjusting screw to obtain a maximum output level.
3-7. Tape Speed Check and Adjustment
1)Confirm that the Pitch control knob is at center position.
2)Connect a frequency counter or wow & flutter meter with frequency counter to the TAPE OUT and playback the Model 9152 test tape.
3)Check the tape speed and wow & flutter if they satisfy the following specifications.
Tape Speed: | 3000 Hz ± 30 Hz at both BOT (beginning of tape) and EOT (end of tape) positions |
Wow & Flutter: | 0.25 % (CCIR WTD) at both BOT and EOT positions |
4)If the tape speed is not within the above specification, adjust R43 (3.3 kΩ) on the R/P AMP PCB assy.
5)Next, check if the tape speed variable range satisfies the specifications below.
Maximum tape speed: +12 % or more (3360 Hz or more)
Minimum tape speed:
3-8. Playback Level Calibration
1) Set the controls as follows.
Record track select switch: OFF
Dolby B noise reduction on/off switch: OFF
2) Connect an AC volt meter to the TAPE OUT 1 through 4 pin jacks.
10
