Foundations SI259D, 100-SS manual Assembly Instructions, Operation, USE of Restraint System

Door / wall plate to be mounted on outside of restroom door.

ASSEMBLY INSTRUCTIONS

ADULT INSTALLATION REQUIRED.		A	B	C
TOOLS REQUIRED:
Level (A)
Measuring tape (B)
Power drill (C)
•	READ ALL INSTRUCTIONS BEFORE ASSEMBLY OF DIAPER CHANGING STATION
•	Unpack carton and identify all parts.	WARNING
•	This changer has six (6) recess mounting holes.
	The diaper changing station is no stronger than the anchors or walls to which they are attached and, therefore,
•	MUST be firmly secured in order to support the weight they are intended to support. It is recommended that this unit be
	installed in a recessed fashion. If surface mounting, contact an architect, building contractor, or Professional Engineer
•	for proper installation and hardware. Contact an architect or building contractor if any questions.
	Child should never be left unattended.
	Avoid serious injury from falling or sliding out. Always use restraint system.
•	Adding excessive weight such as parcels, packages, or accessories to the unit or to the bag hooks that exceed the total
•	weight limit of 50 pounds (22.7 kg) may cause the unit to be unstable or may cause a hazardous unstable condition to
	exist.	PARTS LIST
Parts Description				Quantity
Door / Wall Plate				1
IMPORTANT: Due to widely varied wall material,
anchoring to be determined by architect or engineer.

21 3/8

(543 mm)

			A.D.A. Compliance:
			4.4.1	Maximum Protruding Objects
	18”		4.2.5	Forward Reach
			4.2.6	Parallel Approach
(457 mm) (R)			4.27.4	Operation
		34”
21-3/8”			Compliant when properly installed.
(543 mm) (SM)		(864 mm)
OPERATION:

Rotate base downward. Place infant on top of the changing surface. Use restraint system as described below. After child has been changed, remove restraint system and rotate base back up against the wall.

USE OF RESTRAINT SYSTEM:

Place child so restraint strap is located at abdomen. Rotate top of buckle upward and insert strap in buckle. Pull strap through buckle until snug against infant. Rotate top of buckle downward to lock the strap into place. Slide red locking tab over top of buckle (Fig. a). Reverse steps to loosen strap.

MAINTENANCE AND CLEANING:

Check all hardware and components monthly or as required to ensure hardware is tight and there are no missing or damaged components. Take unit out of service if any component is missing or damaged and contact customer service to order replacement parts. Do not substitute parts.

For replacement parts, contact customer service at 1-877-716-2757.

Clean by using a damp cloth with mild soap or mild multi-purpose cleaner. Do not use any strong chemical cleaners or cleaning agents that may be hazardous to children.

1

Top Of	Locking
Buckle	Tab

Fig. a