INSTALLATION - RECESSED
For A. D. A. compliance, top of lower double stud should be 30.5“ (78 cm) from the floor.
Recommended Blocking:
Wood double stud blocking is necessary. Contact an architect
1" | 34 1/2" |
|
(876 mm) | TOP | |
(25.4 mm) | 3 7/8" | |
| VIEW | |
| (98.4 mm) |
and building official to make sure the blocking is adequate and complies with building codes (Fig b).
1. | Slide changer into blocking area and mark mounting hole |
| location on blocking studs. |
| HINT: This may require 2 additional people to help hold |
2. | changer in position while you are marking the locations. |
Shim changer for a snug fit. |
For A. D. A.
Compliance
30.5”
34 1/2" (876 mm)
Double Stud
Stud |
| |
Double | 19.4" | |
(492 mm) | ||
|
Double Stud
Double Stud
FRONT
21 3/4" VIEW
(552 mm)
3. | Align holes in changer with marked holes and secure using |
| the appropriate fasteners (Fig. c). |
| NOTE: It is installers responsibility to provide correct |
| fastereners for other substrates. |
4. Ensure all six (6) fasteners are tight. | |
(78 cm)
A. F. F | Fig. b |
|
|
| |
| Recess | Recess |
| Mounting | |
| Holes | Mounting |
| Recess | Holes |
|
| |
| Mounting |
|
| Holes |
|
INSTALLATION - SURFACE-MOUNT
Fig. c
Recommended Blocking:
If the walls do not have studs on center, then additional blocking is necessary (Fig. d).
Contact an architect or building contractor to make sure the blocking is adequate and complies with building codes.
For A. D. A. compliance, measure up 50 1/4” (128 cm) from the floor and mark the wall. This locates the position for the top left attachment hole.
NOTE:- Changer MUST be mounted to studs (Fig. e).
- This unit incorporates a finishing collar that seats behind the changer’s outside flange. Center the collar as the unit is being tightened against the wall (Fig. f).
For A. D. A.
Compliance
50 1/4”
(128 cm)
14” (356 mm) on center
A. F. F
Top
32"
(813 mm) on center
Fig. d
Holes
Collar
Wall | Unit |
