3.Add shims as needed in the area shown to bring dishwasher up to proper height.
NOTE: Shims must be securely attached to floor to prevent their movement when the dishwasher is operated.
2"
(5.1 cm)
shim |
|
|
|
|
|
|
| shim | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6" | |||
(15.2 cm) | |||
(7.0 cm) | (7.0 cm) | ||
|
Install the door handle (on some models)
IMPORTANT: Do not scratch the front panel during this procedure.
1.Remove the door handle and hardware bag containing the setscrews and Allen wrench from the cardboard box.
2.Start set screws in handle.
3.Place handle on mounting studs with the set screws facing down.
4.Push the door handle tightly against the door. Insert the short end of the Allen wrench into the setscrews. Tighten the setscrews 1/4 turn past snug. Retain Allen wrench with Installation Instructions.
mounting 
stud
handle
setscrew (in bottom of handle)
Allen wrench
Install the door handle—Pro Line® series
1.Remove the Pro Line® series handle and two screws from handle package.
2.Make sure plastic spacers are still attached to the door.
3. Attach the handle to the |
| |
plastic spacers | ||
front panel as shown. | ||
|
Install door panel—Pro Line® series
For top vented models with a
1.Remove the carton containing the
2.Remove the handle package from the front of the shipping base.
3.With a TORX® screwdriver, remove three screws on both sides, as shown; hold the outer panel up while removing the screws. Save screws for reinstallation.
4.Gently set outer panel aside.
3 screws
3 screws
outer panel
5.Lay the
6.Place the outer panel on the back of the full front panel; align screw holes.
7.Attach outer panel to full front panel panel with the four
4 screws
hex head 
screw
full front panel
top edge
outer panel
8.Attach the panel assembly to the door by reinstalling the two uppermost side screws; do not tighten screws completely. This will hold the panel assembly in place on the door frame.
2 screws
11
