Mounting the hood body |
| Vr |
• Before attaching the hood body, tighten the two screws Vr lo- |
|
|
cated on the hood body mounting points. |
|
|
• Hook the hood body onto the screws 12a. |
|
|
• Fully tighten support screws 12a. |
|
|
• Adjust screws Vr to level the hood body. | 12a |
|
|
| |
Connections |
|
|
DUCTED VERSION AIR EXHAUST SYSTEM |
|
|
When installing the ducted version, connect the hood to the | ø 150 | ø 120 |
chimney using either a flexible or rigid pipe ø 150 or 120 mm, |
| 9 |
the choice of which is left to the installer. |
|
|
• To install a ø 120 mm air exhaust connection, insert the re- |
|
|
ducer flange 9 on the hood body outlet. |
|
|
•Fix the pipe in position using sufficient pipe clamps (not sup- plied).
•Remove any activated charcoal filters.
14.1
| RECIRCULATION VERSION AIR OUTLET |
|
• | Put connection 15 into the connection support 7.3. |
|
• | Insert the connection extension pieces laterally 14.1 in connec- | 15 |
| tion 15. |
|
• | Make sure that the outlet of the extension pieces 14.1 is hori- | ø 150 |
| zontally and vertically aligned with the chimney outlets. | |
• | Connect the air outlet connection 15 to the hood body outlet |
|
| using either a flexible or rigid pipe ø 150 mm, the choice of |
|
| which is left to the installer. |
|
• Ensure that the activated charcoal filters have been inserted.
EN |
| 1 |
| 17 |
