Franke Consumer Products FNE 368 TC W Charcoal filter ductless version, Lighting, W halogen light

Charcoal filter (ductless version)

This filter cannot be washed or regenerated. It must be replaced when the C appears on the display or at least once every 4 months. The filter saturation alarm has to be activated already before.

Activation of the alarm signal

•In the recycling version hoods the filter saturation alarm must be activated during the instal- lation or later.

•Switch off the hood and the lights.

•Press the E-key for about 5 seconds until the last two segments of the motor LEDS are lit on the display.

•By releasing the E-key the clock icon starts to flash.

•Within 3 seconds press the D-key to activate/deactivate charcoal filter saturation alarm.

•C-symbol lit - charcoal filter saturation alarm ACTIVATED.

•C-symbol unlit - charcoal filter saturation alarm DEACTIVATED.

SUBSTITUTION OF THE CHARCOAL FILTER

Alarm reset

•Switch off the motor and the lighting system.

•Press the G-key for at least 2 seconds.

Substitution of the filter

•Open the comfort panel.

•Remove the metal grease filters.

•Remove the charcoal filter as indicated in the picture.

•Place the filter again into its seat.

•Place again the metal grease filters into their place.

Lighting

LIGHT REPLACEMENT

20 W halogen light.

• Remove the snap-on lamp cover by levering it from under the metal ring, supporting it with one hand.

•Remove the halogen lamp from the lamp holder by pulling gently.

•Replace the lamp with a new one of the same type, making sure that you insert the two pins properly into the housings on the lamp holder.

•Replace the snap-on lamp cover.

EN	1
	13