OPERATION
CAUTION: To avoid damage and voiding your warranty, place both units in their upright positions for a minimum of two hours before operating. DO NOT operate unit without air filter properly in place or while tube set is disconnected.
Cooling
This unit is intended to cool a
1.Plug power cord into a standard household outlet. Use this product only with the proper electrical voltage. See “SPECIFICATIONS” on page 3.
WARNING: Do not plug this appliance into an outlet that is being used by other appliances or electrical devices. When installing the electrical plug into the outlet, never touch or bend the metal prongs and always push plug into outlet by using the molded plug. Never use the electrical plug to start or stop the unit and avoid pulling, folding, or stretching the electrical cord.
2.Press Power On/Off ("I/O") button on control panel. The unit will power up and air will begin blowing from the front louvers.
NOTE: This unit is equipped with a special safety time delay feature. The compressor (cooling mechanism) may be delayed for up to five minutes. This safety feature prevents damage to the compressor. The "COMP. ON" light will turn on while the compressor is running.
3.Press “MODE” button on control panel to choose "AUTO," "HI," "MED," "LO," or "FAN." The FAN setting is for air circulation only and does not provide any cooling. To change from a cooling mode to fan mode, press power on/off "I/O" button to turn unit off. Press power on/off "I/O" button again and immediately press "MODE" button to FAN setting. If the air con- ditioner is
4.Press either "THERMO CONTROL" button to control a colder or cooler setting. The default temperature is 77ÞF. Press right button to lower cooling setting; press left button to raise cooling setting. Each press of the button will adjust the temperature approximately 1ÞF. The temperature set- ting can be adjusted from 68ÞF to 86ÞF.
CAUTION: To avoid injury or damage and voiding the warranty, DO NOT manually adjust the louvers.
5.Press “AUTO SWING” button on control panel to begin oscillating horizontal louvers. The louvers will move slowly up and down for optimum air distribution. Press button again to maintain a desired “fixed” position to distribute more cooling air to one side of the room.
11
