Freescale Semiconductor i.MX27 PDK 1.0 - page 11

About the Boards

Debug Board

9

i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0

Table 1.2 Debug Board Physical Features

Type Physical Feature

Switches • S1: Power button

• S2: Debug board rese t button

• S3: System reset switch

• S4: Power-on switch

• SW4: Enable switch

Connectors • J1:10/100 Base-T Ethe rnet RJ45 connecto r

• J2: 5.0V DC power connector

• J3: Current measure connector

• J4: 500-pin connector to CPU board

• P1: WEIM Address me asure connector

• P2: WEIM Data measure connecto r

• CN1: i.MX27 JTAG co nnector

• CN2: Debug board CPL D JTAG connector

• CN3: Personality boa rd CPLD JTAG conne ctor (Reserved)

• CN74: 500-pin connector to Personality board

• CON4: UART (DCE) DB9 female connector

LEDs • D1–D8: LEDs for CPLD debug

• D9: LED for Debug bo ard 3.3V power

• D11:LED for DC power supply

Buttons • BT1, BT2: Test buttons for CPLD

Fuse • F1: Resettable Fuse

3StackQS_WinCE.book Page 9 Friday, November 21, 2008 11:46 AM

Contents

Main Page 1 About the Boards 3 2 Getting Started 13 3 Build the Platfor m 17 4 Using the Demo Image 25 Page About the Boards About the 3-Stack Platform System Page About the 3-Stack Platform System 5 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Table 1.1 3-Stack Platform Features Details Page CPU Board CPU Board Debug Board 8i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Debug Board Figure 1.2 Debug Board Debug Board TOP Bottom Page Page Personality Board 11 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Personality Board TOP Bottom Figure 1.3 Personality Board Personality Board Personality Board 12 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 Table 1.5 Personality Board Physical Features Type Physical Feature Getting Started Unpack the Kit Page CD-ROM Contents 15 i.MX27 PDK 1.0 Quick Start Guide, Rev. 1.0 CD-ROM Contents Table 2.2.identifies the items on t he CD-ROM set. Table 2.2 Development PC Requirements Type Requirement Provide a Development PC Build the Platform Build a Development Platform: Assemble Three Boards Connect Personality Board to Debug Board Connect CPU Board to Debug Board Connect Development Platform to PC; Run Preloaded Image Build a Demo Platform: Assemble Two Boards Connect CPU Board to Personality Board Page Connect Power Supply; Run Preloaded Demo Page Using the Demo Image Touch Pad Calibration Tool Page Downloading Multimedia to the 3-Stack Board Using Active Sync Page Page Page Page Using an SD Card Using a USB Memory Stick Running the Demo Applications Running the TV-Out Application Page Page Page Page Page Page Page Page Ready to Begin Your Development?